Products

Products > Pipe Hangers & Devices > Center Load Clamps

Click on a figure number to see full information in PDF format.

610 & 620
Standard Duty & Heavy Duty
Center Load Beam Clamps

Function: Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp’s design allows the load to be distributed equally on either side of the beam. Normally used in conjunction with Fig. 50 eye rod (standard only), Fig. 55 welded eye rod or Fig. 35 weldless eye nut.

Material: Low carbon steel, available in stainless steel

Finish: Plain

Ordering: Specify type number, width of flange and figure number.
  • Fig. 610 Standard Duty Center Load Beam Clamp
  • Fig. 620 Heavy Duty Center Load Beam Clamp

    Approvals: Complies with Federal Specification A-A-1192A (Type 21) and Manufacturers’ Standardization Society ANSI/SP-69 and SP-58 (Type 21).
    • 625
    Steel Center Load Beam Clamp

    Function: Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp provides a vertical adjustment of approximately 2".

    Material: Low carbon steel, available in stainless steel

    Finish: Plain

    Ordering: Specify rod size, flange width and figure number.
    630
    Malleable Iron
    Center Load Beam Clamp

    Function: Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp’s design allows the load to be distributed equally on either side of the beam. The clamp is adjustable from 23/8" to 7" and can be used with flange thicknesses up to .60 inches. Normally used in conjunction with Fig. 25 extension piece. An additional 1" or more of vertical adjustment is obtained when used with Fig 25.

    Material: Malleable iron

    Finish: Plain

    Ordering: Specify figure number. If extension piece is required, order Fig. 25 extension piece separately.

    Approvals: Complies with Federal Specification A-A-1192A (Type 30) and Manufacturers’ Standardization Society ANSI/SP-69 and SP-58 (Type 30).
    632
    Steel Center Load Beam Clamp

    Function: Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp's design allows the load to be distributed equally on either side of the beam. The clamp is adjustable and normally used in conjunction with Fig. 35 weldless eye nut. An additional 1" or more of vertical adjustment is obtained when used with Fig. 35.

    Material: Carbon steel

    Finish: Plain, electro-galvanized, or hot dipped galvanized

    Ordering: Specify figure number, type, finish, and eye nut.

    Approvals: Complies with Federal Specification WW-H-171E & A-A1192A (Type 28 without links) (Type 29 with links) and Manufacturers' Standardization Society SP-69 (Type 28 without links) (Type 29 with links) when used with Fig. 35.
    635
    Adjustable Steel Beam Clamp

    Function: Designed to be used in the suspension of a hanger rod from an I-Beam. The clamp is adjustable from 31/2 to 8" and can be used with flange thicknesses up to .75 inches.

    Material: Low carbon steel, available in stainless steel

    Finish: Plain

    Ordering: Specify rod size and figure number.

    Approvals: Complies with Federal Specification A-A-1192A (Type 27) and Manufacturers’ Standardization Society ANSI/SP-69 and SP-58 (Type 27).
    Copyright © 2010 PHD Manufacturing, Inc. | Designed By Techni-Graphics Inc. | Developed By Miles Oldenburg