Import Beam Clamp

Figure: 350


Designed for attaching hanger rod to the top flange of a beam or bar joist, where the flange thickness does not exceed 3/4 inch (19.05mm). The open U design permits rod adjustment.

Material: Malleable iron with hardened steel cup point set screw and locknut (Type 304 or 316 Stainless Steel upon request for 1/4”, 3/8”, and 1/2” only)

Finish: Plain or electro-galvanized

Approvals: Underwriters’ Laboratories Listed in the U.S. (UL), Canada (CUL), for sizes 1/2” to 7/8” malleable iron only. Factory Mutual Approved for rod size 1/2” malleable iron only. Complies with Federal Specifications A-A-1192A (Type 19) and Manufacturers’ Standardization Society ANSI/MSS SPSP-58 (Type 19) which supersedes ANSI/MSS SP-69. (Approvals are only valid for beam clamps with locknut).

Ordering: Specify figure number, rod size, material, and finish.

NOTE: When a torque wrench is unavailable, the setscrew should be tightened so it contacts the I-beam and then an additional 1/4  to 1/2 turn.

View Data Sheet